Orien FS260IM Spezifikationsblatt PDF herunterladen (Seite 13)

Operation

Final Check List before Operation

1. Have all packing materials and tape been removed from the interior and exterior of the ice

maker?

2. Did you clean the ice storage bin? (See pages 15 - 17.)

3. Have the installation instructions been followed, including connecting the machine to water

and electricity?

4. Has the machine been leveled?

5. Is the ice cube machine in a site where the ambient temperature is between 50º F (10º C) and

100º F (38º C) and the

water temperature between

41º F (5º C) and 90º F (32º C) all

year

round?

6. Has the water supply pressure been checked to ensure a minimum of 15 psig with a static

pressure not to exceed 80 psig?

7. Is there a clearance of at least 6″ (150 mm) at the rear, 1″ (25 mm) at the top and sides for

proper air circulation?

8. Has the power supply voltage been checked or tested against the nameplate rating? And has

proper grounding been installed for the ice cube machine?

9. Is the ice cube machine plugged in?

10. Have you turned on the main water supply and the tap?

11. Have you checked for leaks at all water supply connections?

Operating Method

1. Turn on the water tap, letting the water enter the water tank, then turn the power switch ON.

The power switch’s indicator lamp lights, as well as the other three indicator lights on the

control panel.

2. After about 3 minutes, the ice maker will automatically proceed to the ice-making stage, and

the sound of flowing water will be heard. Only the red power switch lamp and the green Ice

Making LED will be on.

3. When the

batch

of ice has been fully

formed,

ice will

automatically

fall into the ice

storage

bin.

The yellow Ice Harvest LED and power switch LED are on, and the other two LEDs are off.

4. When the ice storage bin is full, the sheet of cubes will not fall completely and will hold t

bin

full probe open. The machine is in the bin full mode, and the red Bin Full LED is lit. The

power switch LED is on and the other two LEDs are off.

5. The unit starts making ice again automatically approximately 3 minutes after ice cubes are

removed. As ice is removed, the bin full probe swings back to operating position.

IMPORTANT:

Ice-making stage Ice harvest stage

• Although the unit has been tested and cleaned at the factory, due to long-term transit and

storage, the first batch of cubes must be discarded.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Orien FS260IM Spezifikationsblatt Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Eiswürfelmacher Orien FS260IM